Coffee
How we pull a flat white
A double shot, a thin layer of milk and about forty seconds. Here's what happens behind the machine.
Mara Lind
3 min read

The flat white is the drink we make more than any other. On a busy Saturday it's somewhere north of two hundred cups, and every one of them goes through the same four steps: a shot, some milk, a pour and a small cup. It takes about forty seconds from start to finish, which is not very long, and also long enough to get almost every part of it wrong.
The shot
We pull a double ristretto for every flat white. It's a shorter, sweeter shot than a standard espresso, and it holds its shape under milk instead of disappearing into it. Ristretto just means "restricted": the same amount of coffee in the basket, but we stop the shot earlier, so you get less liquid and more of the good, syrupy part that comes out first.
The first shot of the morning always gets tasted. If it runs fast and tastes thin, we tighten the grind. If it drips and turns bitter, we open it up. It takes three or four tries most days, and nobody gets served until it's right. The person on the bar usually drinks the rejects, which explains a lot about how fast we talk before nine.
The milk
Whole milk, steamed to around 60°C. Hotter than that and it starts to taste cooked; cooler and it goes flat before you reach the table. At 60°C the sugars in the milk taste their sweetest, which is why a well-steamed flat white can taste sweet without any sugar in it at all.
We're after silk, not foam. The wand goes just under the surface for a second or two to let in a little air, then down deeper to spin the milk until it looks like wet paint. If you can see bubbles, it's a cappuccino in disguise.

The pour
Start high and slow, so the milk sinks under the crema and mixes with the coffee. Then bring the jug close and speed up, and the white sits on top. Most mornings it's a plain heart. On quiet afternoons someone will try a rosetta, and we'll all pretend we didn't see the first three.
A good pour isn't about the picture. It's proof the milk was right, because you can't draw with bad milk.
The heart on top isn't decoration so much as a quality check you can see from across the room. If the milk was too foamy, the heart blurs into a blob. If it was too thin, it sinks and disappears.
The cup
A flat white lives in a small cup, about 160ml. Two ristretto shots with 160ml of milk is coffee-forward and smooth. The same shots in a big cup turn into warm milk that once met a coffee bean.
We warm our cups on top of the machine. A cold cup steals heat from the milk straight away, and the whole drink drops a few degrees before it reaches you. It's a tiny thing, but this whole drink is made of tiny things.

Trying it at home
You don't need our machine to make a decent flat white, but you do need a steam wand and a bit of patience. Here's what we'd tell a friend:
• Use beans roasted in the last two to four weeks.
• Grind finer than you think, so the shot runs like warm honey.
• Start with cold milk in a cold jug.
• Tap the jug and swirl until the surface looks glossy.
• Change one thing at a time.
Your first ones will probably look nothing like ours. Mara, who runs our bar, says she poured roughly a thousand bad hearts before she poured a good one.
So next time you're in, ask whoever's on the bar how the first shot tasted this morning. They'll tell you, probably in more detail than you wanted, and then they'll hand you a flat white.
Written by
Mara Lind
Notes from the CaféLio kitchen and counter on Cherry Lane.


